GCV Air Classifying Mill
Features
- Available D50:2～45μm.
- Classifying wheel is installed vertically.
- Integration of grinding and classifying, classifying wheel is adjusted to obtain ideal particle.
- With hydraulic turnover device, convenient for maintenance.
- Compact structure and small occupation,easy to disassemble and clean, no dead angle design.
- Lower installation power, widely application, high cost-performance.
- Different types of grinding disc (pin, hammer, teeth or others) are used based on characteristics of materials to obtain different grinding forces and improve grinding efficiency.
- Key parts like the hammer, gear ring and classifying wheel are made by ceramic such as aluminum oxide, zirconium oxide or silicon carbide to ensure zero contact with metal throughout the pulverization process to meet the requirements of high purity materials.
- Grinding is in closed system, little dust, low noise, clean and environmentally friendly production process.
- PLC control system, easy operation.
- Low noise design.
- Optional explosion-proof design to meet the requirements of ultra-fine grinding processing of flammable and explosive oxide materials.
- High-temperature, low-temperature, normal-temperature, airtight cycle, Inert gas cycle designs are available, for different grinding requirements of different materials.
GCV Air Classifying Mill
Process flow
GCV Air Classifying Mill
Parameter
Parameter | GCV300 | GCV400 | GCV500 | GCV700 | GCV900 | GCV1100 | GCV1300 |
Grinding rotor diameter(mm) | 300 | 400 | 500 | 700 | 900 | 1100 | 1300 |
Max Grinding rotor speed(rpm) | 7500 | 4800 | 4200 | 3000 | 2350 | 1920 | 1625 |
Grinding motor power(kW) | 7.5 | 22 | 30 | 45 | 75 | 110 | 200 |
Classifying motor power(kW) | 2.2 | 4 | 5.5 | 7.5 | 15 | 22 | 37 |
Max Classifying rotor speed(rpm) | 4500 | 3200 | 3000 | 2900 | 2200 | 1800 | 1500 |
Max Air Flow(m³/h) | 700 | 1600 | 3000 | 4500 | 8000 | 12000 | 16500 |
Capacity ratio factor | 0.3 | 1 | 1.4 | 2.2 | 4 | 6 | 10 |
(The above parameters are for reference only, subject to the design parameters when ordering.)
Other products
GCH Air Classifying Mill
Available D50:1.5～15μm.
Classifying wheel is installed Horizontally.
Integration of grinding and classifying, classifying wheel is adjusted to obtain ideal particle.
GCD Air Classifying Mill
Available D50:3～75μm.
Classifying wheel is installed vertically.
Two-In-One shaft of grinding disc and classifying wheel, compact structure.